Changan Aotuo new model
LQSQP
69$
Availability: | |
---|---|
Quantity: | |
Product introduction
Factory supply catalytic converters for Changan Aotuo new model,This product we use high-quality raw materials 409 stainless steel, and with high flow ceramic carrier, to help each car can purify exhaust gas, reduce fuel consumption, improve power, and extinguish engine failure lights!
First, significantly improve exhaust emissions
Efficient purification of harmful gases
Through the REDOX reaction, the carbon monoxide (CO), hydrocarbons (HC) and nitrogen oxides (NOx) in the tail gas are converted into harmless carbon dioxide (CO₂), water (H₂O) and nitrogen (N₂), greatly reducing pollutant emissions. After installation, the concentration of harmful substances in the exhaust gas will be significantly reduced, in line with environmental standards, and avoid annual inspection failures caused by excessive emissions.
Reduce odors and environmental pollution
An uninstalled or aged three-way catalytic converter may result in a pungent exhaust. After replacement, the exhaust odor is significantly reduced, while reducing the negative impact on air quality.
Second, optimize the engine operation state
Improve fuel efficiency and power response
Three-way catalyst and oxygen sensor work together:
The front oxygen sensor detects the oxygen content of the tail gas and feeds back to the ECU to adjust the air-fuel ratio, so that the combustion is more full and the fuel efficiency is improved.
If the catalytic converter fails, the ECU may misjudge the air-fuel ratio, resulting in reduced power or increased fuel consumption. After the replacement, the engine control is more accurate and the throttle response is more sensitive.
Avoid failure light alarm
Post-oxygen sensor monitors catalytic converter efficiency. If the catalytic converter fails, the front and rear sensor data are consistent and the fault light will be triggered. Replacing a qualified new catalytic converter can eliminate such alarms and ensure the normal operation of the system.
Third, extend the service life and maintenance costs
Reasonable use can extend life
If the new catalytic converter is properly installed and uses high-quality fuel (avoid lead pollution), the life span can reach 80,000 to 100,000 kilometers. Poor quality fuel or engine failure (such as burning oil) may shorten its life and require regular inspection and maintenance.
Reduce maintenance risk
Aging catalytic converters may increase exhaust resistance due to blockage, resulting in engine overheating or power loss. Avoid such problems after replacement and reduce the risk of damage to other components of the exhaust system, such as the exhaust pipe.
4. Potential problems and run-in period that need attention
Running-in and adaptation after installation
The new catalytic converter needs a short run-in (usually a few minutes to ten minutes), until the temperature rises to more than 250°C to work effectively, and the best catalytic effect is 400-800°C.
Not a one-size-fits-all solution
If the exhaust gas is still unqualified after replacement, it may be caused by engine failure (such as valve leakage, insufficient combustion), which needs comprehensive investigation rather than relying only on the catalytic converter.
5. Economic and environmental benefits
Reduce long-term operating costs
The original catalytic converter contains platinum, rhodium and other precious metals, and the replacement cost is high (up to thousands of yuan). However, reasonable maintenance of the new catalytic converter can avoid frequent replacement and save maintenance costs.
Environmental compliance and vehicle value preservation
Comply with national six strict emission standards, avoid restrictions on the road due to exhaust problems or affect the value of used cars.
Product introduction
Factory supply catalytic converters for Changan Aotuo new model,This product we use high-quality raw materials 409 stainless steel, and with high flow ceramic carrier, to help each car can purify exhaust gas, reduce fuel consumption, improve power, and extinguish engine failure lights!
First, significantly improve exhaust emissions
Efficient purification of harmful gases
Through the REDOX reaction, the carbon monoxide (CO), hydrocarbons (HC) and nitrogen oxides (NOx) in the tail gas are converted into harmless carbon dioxide (CO₂), water (H₂O) and nitrogen (N₂), greatly reducing pollutant emissions. After installation, the concentration of harmful substances in the exhaust gas will be significantly reduced, in line with environmental standards, and avoid annual inspection failures caused by excessive emissions.
Reduce odors and environmental pollution
An uninstalled or aged three-way catalytic converter may result in a pungent exhaust. After replacement, the exhaust odor is significantly reduced, while reducing the negative impact on air quality.
Second, optimize the engine operation state
Improve fuel efficiency and power response
Three-way catalyst and oxygen sensor work together:
The front oxygen sensor detects the oxygen content of the tail gas and feeds back to the ECU to adjust the air-fuel ratio, so that the combustion is more full and the fuel efficiency is improved.
If the catalytic converter fails, the ECU may misjudge the air-fuel ratio, resulting in reduced power or increased fuel consumption. After the replacement, the engine control is more accurate and the throttle response is more sensitive.
Avoid failure light alarm
Post-oxygen sensor monitors catalytic converter efficiency. If the catalytic converter fails, the front and rear sensor data are consistent and the fault light will be triggered. Replacing a qualified new catalytic converter can eliminate such alarms and ensure the normal operation of the system.
Third, extend the service life and maintenance costs
Reasonable use can extend life
If the new catalytic converter is properly installed and uses high-quality fuel (avoid lead pollution), the life span can reach 80,000 to 100,000 kilometers. Poor quality fuel or engine failure (such as burning oil) may shorten its life and require regular inspection and maintenance.
Reduce maintenance risk
Aging catalytic converters may increase exhaust resistance due to blockage, resulting in engine overheating or power loss. Avoid such problems after replacement and reduce the risk of damage to other components of the exhaust system, such as the exhaust pipe.
4. Potential problems and run-in period that need attention
Running-in and adaptation after installation
The new catalytic converter needs a short run-in (usually a few minutes to ten minutes), until the temperature rises to more than 250°C to work effectively, and the best catalytic effect is 400-800°C.
Not a one-size-fits-all solution
If the exhaust gas is still unqualified after replacement, it may be caused by engine failure (such as valve leakage, insufficient combustion), which needs comprehensive investigation rather than relying only on the catalytic converter.
5. Economic and environmental benefits
Reduce long-term operating costs
The original catalytic converter contains platinum, rhodium and other precious metals, and the replacement cost is high (up to thousands of yuan). However, reasonable maintenance of the new catalytic converter can avoid frequent replacement and save maintenance costs.
Environmental compliance and vehicle value preservation
Comply with national six strict emission standards, avoid restrictions on the road due to exhaust problems or affect the value of used cars.
Q1: Where is your factory?
A: We are located in Dezhou City, Shandong Province, China (Mainland).
Q2: How about the products packaging?
A: Generally we wrap our goods in poly-film , carton box and pallet and we can also pack the products as customers request.
Q3: What is your terms of payment?
A: T/T 30% as deposit, and T/T 70% before delivery. We’ll show you the photos of the products and packages before you pay the balance.
Q4: How about the delivery time?
A: Generally, it will take 30 to 45 days after receiving your advance payment. The specific delivery time depends on the items and the quantity of your order.
Q5: Can you produce according to the samples?
A: Yes, if you buy in large quantity we can produce by your samples or technical drawings. We can build molds and fixtures.
Q6: What is your sample policy?
A: We can supply the sample if we have ready parts in stock, but the customers need to pay the samplecost and the courier fee.
Q7: Do you test all your goods before delivery?
A: Yes, we have 100% test before delivery.
Q8: How do you make our business long-term and good relationship?
A: We keep good quality and competitive price to ensure our customers’ benefit. We respect every customer as our friend and we sincerely do business and make friend with them no matter where they are from.
Q9: Do you have any guarantee?
A: Yes, one year for our product quality assurance, and product life span is 50 thousand kilometers' driving.
Q10: What is the minimum order quantity?
A: 1 Set
Q11: Payment method?
A: T/T
Q12: About the freight?
A: We provide the buyer with the lowest factory price, all the freight generated by the buyer bear!
Q13: How to install?
A: It is recommended to go to the local repair shop to install, because they have complete tools, replace the old exhaust pipe, tighten the screw, the original location installation, very convenient!
Q1: Where is your factory?
A: We are located in Dezhou City, Shandong Province, China (Mainland).
Q2: How about the products packaging?
A: Generally we wrap our goods in poly-film , carton box and pallet and we can also pack the products as customers request.
Q3: What is your terms of payment?
A: T/T 30% as deposit, and T/T 70% before delivery. We’ll show you the photos of the products and packages before you pay the balance.
Q4: How about the delivery time?
A: Generally, it will take 30 to 45 days after receiving your advance payment. The specific delivery time depends on the items and the quantity of your order.
Q5: Can you produce according to the samples?
A: Yes, if you buy in large quantity we can produce by your samples or technical drawings. We can build molds and fixtures.
Q6: What is your sample policy?
A: We can supply the sample if we have ready parts in stock, but the customers need to pay the samplecost and the courier fee.
Q7: Do you test all your goods before delivery?
A: Yes, we have 100% test before delivery.
Q8: How do you make our business long-term and good relationship?
A: We keep good quality and competitive price to ensure our customers’ benefit. We respect every customer as our friend and we sincerely do business and make friend with them no matter where they are from.
Q9: Do you have any guarantee?
A: Yes, one year for our product quality assurance, and product life span is 50 thousand kilometers' driving.
Q10: What is the minimum order quantity?
A: 1 Set
Q11: Payment method?
A: T/T
Q12: About the freight?
A: We provide the buyer with the lowest factory price, all the freight generated by the buyer bear!
Q13: How to install?
A: It is recommended to go to the local repair shop to install, because they have complete tools, replace the old exhaust pipe, tighten the screw, the original location installation, very convenient!